45 FAQUpdated 2 months ago

45 FAQ

How Do I Operate the 45?

1. Place the pistol on safe.
2. Press the magazine release button on the left side to remove the magazine.
3. Slide the grip to the rear to expose the CO2 port.
4. Ensure the CO2 screw is fully unscrewed.
5. Add a drop of recommended oil to the tip of the CO2 cylinder and insert it. Screw in the CO2 until pierced and sealed. Do not overtighten.
6. To load the magazine:
   • Pull the follower down until it locks into place.
   • Be careful not to bump the protruding nub at the bottom of the magazine while loading.
   • Tilt the magazine downward and insert up to 20 BBs.
   • Place a finger over the end of the magazine and pull the nub toward you to release the follower.
7. Insert the magazine into the pistol until it clicks. The pistol is now ready to fire.
8. When you are done using your 45, remove the CO2 cylinder. Never leave a CO2 cylinder installed, doing so will wear out your seals and void your warranty.

Video for loading magazine: https://www.youtube.com/watch?v=CBQv2Y1F7TE

How Do I Use the Sights Correctly?

• Align the front sight within the rear notch, with your target resting on top of the alignment.
• The sights are fixed, so if the point of impact differs from the point of aim:
  • Clean the barrel.
  • Experiment with different brands of BBs for improved accuracy.

How Do I Replace the Seal Assembly?

1. Disassemble the gun as described in the disassembly FAQ.
2. Remove the old seal assembly and replace it with the new seal valve provided.
3. Reassemble the gun by following the disassembly steps in reverse.

Alternative Option:

• If disassembly seems too complicated:
  • Replace only the seal inside the old assembly by unscrewing the section near the seal.
  • You may need to unscrew the new seal from the provided assembly before installing it in the old one.

Note: Reassembly can be tricky due to the precise alignment required. For assistance or questions, contact [email protected].